TABLE OF CONTENTS
Unboxing
You will find the following items inside every bluebot box:
Item | Quantity |
bluebot device | 1 |
10' USB-C power cable | 1 |
C-holders | 2 |
Ultrasonic coupling gel | 1 |
Replacement coupling pads | 6 |
Microfiber towel | 1 |
Sand paper disc | 1 |
Visual Guide
![]() | ![]() (10 feet long, creates a press-tight water resistant fit.) | ![]() (Hold the bluebot clamps open to replace pads) |
(Replacement Pads x6 and Gel are used as needed) | ![]() Microfiber Towel (For removing dirt, dust and debris from the pipe before installation) | ![]() (For sanding away house paint, dirt, or grime on your pipe) |
Maintenance Items
The silver c-holders located below the power cable box are used to prop the device clamps open. This is helpful during inspection and replacement of your ultrasonic pads. Six sets of replacement pads are also included.
Installation Items
Below the bluebot device, you will find a square microfiber towel and a round sandpaper disc. During installation, we encourage you to install bluebot on a clean section of pipe for best results. Sanding away house paint, dirt, grime buildup, etc. from the pipe and cleaning with the microfiber cloth allows bluebot to have an even stronger ultrasonic signal at your location.
Special Use Items
The small tube of ultrasonic coupling gel is included for assistance in specific environments where bluebot is not producing a quality ultrasonic signal result. Most installations do not require the gel to be added and customers should not add gel unless instructed by bluebot support.
If you have any questions or would like to speak to a member of the bluebot team, contact us directly at hello@bluebot.com or call/text (831) 275-2715 M-F 10 AM - 6 PM PST.